TEC - 160kW 3ph 4 Pole High Efficiency 315L frame, Double Ended Shaft, Insulated Bearing Cast Iron AC Motor for 400V 3 phase supply. Use with a suitable AC Frequency Inverter Drives.
Fixed Main Supply Output: 160kW (215HP) x 1490RPM at 400V x 50Hz 3ph. .
Inverter Supply Output: 12:1 speed control range from 149RPM to 1750RPM for 5Hz to 60Hz with suitable de-rating at the lower speeds and when the optional insulated bearing is added.
Full Load Current - 273.4A at 400V.
Efficiency is 94.9% at full load.
Power Factor is 0.89 when mains connected at 50Hz.
Foot mount on 28mm holes at 508mm wide x 508mm centres 216mm back from shaft shoulder.
Flange mount on 8 x 24mm holes equispaced on 600mm PCD with 550mm diameter spigot in the 660mm diameter flange. When horizontal flange mounted, the feet must be supported also. Vertical shaft down mounting requires angular contact bearings, email us for more details if this is a requirement.
Rated at 40C Ambient.
Ventilation space required at rear cooling air intake.
Insulated bearing is included to prevent high frequency Current circulating through the shaft and bearings.
Thermistors are included for over-temperature protection.
Part number is - 160.043TECCB35-IE2-DES-IB
For Variable Speed use…
Part Time Output when Inverter powered is...
873Nm - 160kW (215HP) x 1750RPM at 60Hz
1025Nm - 160kW (215HP) x 1490RPM at 50Hz
1025Nm - 80kW 107HP) x 745RPM at 25Hz
1025Nm - 16kW (21HP) x 150RPM at 5Hz
Continuous Output when Inverter powered is...
873Nm - 160kW (215HP) x 1750RPM at 60Hz
1025Nm - 160kW (215HP) x 1490RPM at 50Hz
871Nm - 68kW (91HP) x 745RPM at 25Hz
512Nm - 8kW (10.7HP) x 150RPM at 5Hz
Download the full Technical Catalogue from the link below...
From Jan 1st 2017, three phase electric induction motors with a rated output of 0.75kW to 375kW and efficiency less than IE3 must be equipped with a variable speed drive (Inverter Drive). For exceptions, see EC Commission Regulation 640/2009.