Universal Motors B14 Face Mount Endshield for UMA 71 Frame Motors

B14 Face Mount Endshield for 71 Frame UMA  Universal Motor. Can be used in place of existing B3 End Shield or B5 Flange to convert a motor to B14 or B34 (with feet) configuration.

Consists of B14 Flange only and does not include fixings. Remove existing End Shield or Flange before fitting.

To replace existing End Shield or Flange:-

1. Instructions:

2. Access the Flange
   • Once the motor is free, lay it on a soft surface to avoid scratches.
   • Identify the screws or bolts securing the flange to the motor body.
3. Remove the Existing Flange
   • Use the appropriate allen key/drill bit to remove the screws/bolts.
   • Carefully detach the flange from the motor. If it’s stuck, gently tap it with a rubber mallet.
4. Spring wash
   • Remove the oil seal from the drive end(B3) and tap into the same location of the flange
   • Remove the Spring washer from the bearing housing and keep for the next step
5. Install the New Flange
   • Stand the motor vertically, and place the spring washer on the bearing
   • Align the new flange with bearing house over the spring washer
   • Tap the flange down with a rubber wallet for the bearing house to cover the bearing this will also bring the flange to the fixing point of the motor
6. Secure the Flange
   • Secure the flange with the previously removed bolts
   • Ensure that the flange is evenly secured to avoid any misalignment.