ABB ACS355 AC Frequency Inverter for 7.5kW (10HP) 400V 3 Phase motor in VxF or Sensorless Vector control to 15.6A. Simple to set-up with 400V three phase input for a standard AC Induction motor or permanent magnet synchronous motor.
Supplied with ACS-CP-C Basic Control Panel (keypad). Also available without an operator keypad - see linked products below. Note that the stock quantity shown applies with or without a keypad.
Size R3 - 169mm Wide x 169mm Deep x 169mm high (236mm high including fastenings and clamp plate). IP20.
Weight: 2.9kg.
Overload - 150% x 60 seconds every 10 minutes, 175% x 2 seconds at start
Speed Control Range - 0-600Hz.
Braking at full load for 10 seconds every 120 seconds to 40 Ohm minimum, 60 Ohm Maximum external resistor (not supplied) - 56 Ohm resistor is linked below or use the 'Which Resistor' button on this page.
Features - 2 x Analogue Inputs, 5 x Digital Inputs, 1 x Analogue Output, 1 x Digital Output, 1 x Relay Contact set.
DC Bus terminals with charge limit in circuit for DC supply or common bus energy saving applications.
'Safe Torque Off' function to SIL 3.
Programmable from a PC via 'DriveWindow' or using the ABB FlashDrop tool.
Input Current - 22.1A.
Input Voltage - 380-480V Three Phase at 50/60Hz ±5%.
EMC Filters to IEC/EN 61800-3 2nd Environment C3 (Industrial)
Wall mount in clean environment or cubicle mount.
Rated at 40°C Ambient.
Ventilation space above and below - 75mm.
Ventilation space at sides - 0mm (drives can be mounted side by side)
Heat Loss at max output - 204.2W.
Mounting via 35mm DIN rail at rear or
Mounting via 4 x 5mm diameter holes at rear on 148mm x 191mm centres
(no side mounting with this frame size).
Full part number (without ACS-CP-C) - ACS355-03E-15A6-4 (3AUA0000058191) and is a direct replacement for the equivalent ACS350.
Download the ABB ACS355 Manual from the link below:-