Invertek Optidrive E2 Single Phase Variable Frequency AC Frequency Inverter for a 1.1kW (1.5HP) 230V single phase motor in VxF control to 10.5A. Simple to set up this single phase VFD converts fixed frequency single phase 230V input to single phase variable frequency for a Permanent Split Capacitor (Cap run) or Shaded Pole motor.
The Optidrive E2 has been superseded by the Optidrive E3.
The manufacturer recommends that customers migrate to the E3 as soon as possible as this is a direct replacement.
See linked product below for equivalent rating.
Frame 2 Size - 188mm Wide x 186.5mm Deep x 257mm High, IP66
Overload - 150% Output Current x 60 seconds, 175% x 2 seconds
Speed Control Range - 0/120Hz.
Braking - To 50 Ohm minimum external resistor (not supplied) - use the 'Which resistor' button on this page.
Features - 2 Analogue/Digital Inputs, 2 x Digital Inputs (4 total), 1 x Analogue/Digital Output, 1 Relay Contact set.
Parameter setting via integral keypad, remote keypad (optional) or from a PC via 'OptiStore' software (RS485 to USB cable required - see linked products below)
Parameter setting from compatible Windows based PDA or Smartphone cable-free via 'OptiWand' software
EMC Filters to EN61800-3 category C2 for 1st environments (domestic) for screened cable lengths of up to 5m (add Optifilter for lengths above 5m).
EMC Filters to EN61800-3 cat C3 (2nd environment - Industrial) for screened cable lengths of up to 25m.
Input Current - 16.2A
Input Voltage - 200-240V ± 10% Single Phase
Wall mount in clean environment or cubicle mount.
Rated at 50°C Ambient.
Ventilation space above and below - 75mm.
Ventilation space at sides - 50mm.
Mounting onto symmetrical DIN rail or use the screw fixings for mounting at rear.
Full part number is - ODE-2-22110-1KB4X-01.
Made in the UK.
Download the Invertek Optidrive Manual from the link below:-