Invertek Optidrive E3 IP66 2.2kW 230V 1ph to 3ph AC Inverter, DBr, SW, C1 EMC

Invertek Optidrive E3 IP66 series AC Inverter for 2.2kW (3HP) 230V three phase motor in VxF or sensorless vector control to 10.5A. Converts fixed frequency single phase 230V input to variable frequency 230V to control the speed of a IE2, IE3 or IE4 standard AC Induction Motor, Permanent Magnet motor, Brushless DC Motor or Synchronous Reluctance Motor.

Size 2:  188mm Wide x 187mm Deep x 257mm High. IP66.
Weight: 4.1kg.

Overload: 150% x 60 seconds, 175% x 2.5 seconds
Speed Control Range: 0-500Hz.
Braking (DBr): to minimum 50 Ohm external resistor (not supplied) - see the Linked Products below or use the 'Which Resistor' button on this page.

Integrated operator keypad with LED display, Power on/off switch (SW), Speed Control Potentiometer, Forward/Reverse Swiitch 
2 Digital Inputs, 2 Analogue/Digital Inputs, 1 Analogue/Digital Output, 1 Relay Contact set, RJ45 socket for Modbus RTU or CANopen communications over RS485.
Input Current: 19.2A
Input Voltage: 200-240V Single Phase ±10% (max 240V) at 50-60Hz ±5%
EMC Compliance (C1 EMC): EN61800-3 Category C1 (Industrial and Domestic).

Wall or Cubicle mount.
Rated 50° Ambient (non enclosed).
Ventilation space in front: [Not Specified]
Ventilation space above and below: 200mm
Ventilation space at sides: 10mm
Mounting via 4 x 4mm holes at rear on 176mm x 200mm centres.

Manufacturer part number is ODE-3-220105-1F4Y. Replaces Optidrive E2 of equivalent rating.
Made in the UK.

Download the Invertek Optidrive E3 Manual from the link below:-