Teco E510s Series AC Inverter for 0.75kW (1HP) 230V 3 Ph motor in V/F or Sensorless Vector control to 4.5A. Converts fixed frequency single phase 230V input to variable frequency three phase 230V to control the speed of a standard AC Induction Motor or PM Synchronous Motor.
Frame: 1, 91mm Wide x 152mm Deep x 164mm High (excluding earth clamp).
Enclosure rating: IP20.
Weight: 1.5kg.
Output: 4.5A, 0.75kW at 230V
Overload: 150% x 60 seconds. 200% for 2 seconds
Speed Control Range: 0-599Hz
Braking (DBr): Built-in braking transistor. A 17 Ohm (minimum), 200 Ohm (100% braking torque) external resistor is required for Dynamic Braking. Resistor is not supplied and should only be fitted if this feature is required. Resistor option given below.
LED Keypad
Features: 2 Analogue Inputs, 6 Digital Inputs, 1 Analogue Output, 1 Relay Contact set, 1 NC Relay
Fieldbus: Modbus (RTU and ASCII) and BACnet communication interface included
Safety Function: STO (Safe Torque Off) Dedicated dual input up to SIL2, PLd (Linked out as default, remove links to add safety circuit)
Input Current: 12A
Input Voltage: 380-480V Three Phase +10% -15% at 50-60Hz
Short Circuit Rating: 5kA. Where supply transformer exceeds 600kVA, 3% Impedance AC Line Chokes are required.
15A Fast Acting Fuses or 20A MCCB are required (Operation must be fast enough to ensure Short Circuit rating is not exceeded)
EMC Filters (EMC): IEC EN61800-3 / EN61800-5-1 Class A Category C2 (Industrial and restricted Domestic). Can be disabled if required.
Mounting: Cubicle mount via 4 x M4 holes on 153mm x 80.5mm centres.
Ambient: Rated 50°C.
Ventilation space in front: [not specified].
Ventilation space above and below: 120mm.
Ventilation space at sides: 50mm.
Heat Loss at max output: [not specified]
Manufacturer Part Number: E510-201-SH1F, also known as 11-301-21-201-30. Replaces: E510-201-H1F