Invertek Optidrive E2 IP66 series AC Inverter for 0.75kW (1HP) 230V three phase motor in VxF control to 4.3A. Converts fixed frequency three phase 230V input to variable frequency 230V to control the speed of a standard AC Induction Motor.
The Optidrive E2 has been superseded by the Optidrive E3.
The manufacturer recommends that customers migrate to the E3 as soon as possible as this is a direct replacement.
See linked product below for equivalent rating.
SW (Switched): includes integrated Potentiometer for speed control, Fwd/Stop/Rev and Enable switches.
Size 1: 161mm Wide x 179mm Deep x 232mm High. IP66 (Nema 4X) dust tight and resistant to water spray - indoor use only.
Weight: 3.1kg.
Overload: 150% x 60 seconds, 175% x 2.5 seconds
Speed Control Range: 0-500Hz.
Braking: No dynamic braking.
Integrated operator keypad with 6-digit LED display, 2 Analogue/Digital Inputs, 2 Digital Inputs, 1 Analogue/Digital Output, 1 Relay Contact set, RJ45 socket for Modbus RTU communications over RS485 or PC Connection to OptiTools Studio software.
Input Current: 8.5A
Input Voltage: 200-240V Single Phase ±10% (max 240V) at 50-60Hz ±5%
EMC Compliance: IEC EN61800-3:2004 Category C1 (Industrial and Domestic).
Wall mount.
Rated 40° Ambient.
Ventilation space in front: [Not Specified]
Ventilation space above and below: 200mm
Ventilation space at sides: 10mm
Mounting via 4 x holes for M4 bolts at rear on 148.5mm x 189mm centres.
Manufacturer part number is ODE-2-12075-1KB1Y. Equivalent to HP model number ODE-2-12010-1HB1Y.
Made in the UK.
Download the Invertek Optidrive E2 Manual from the link below:-