Invertek Optidrive E3 IP66 Outdoor series AC Inverter for 0.75kW (1HP) 230V three phase motor in VxF or sensorless vector control to 4.3A. Converts fixed frequency Single Phase 230V input to variable frequency 230V to control the speed of a standard AC Induction Motor, Permanent Magnet motor, Brushless DC Motor or Synchronous Reluctance Motor.
Output Current: 4.3A (continuous)
Overload: 150% x 60 seconds, 175% x 2.5 seconds
Size 1: 161mm Wide x 179mm Deep x 232mm High.
IP Rating: IP66 with UV protection for Outdoor use (Outdoor). Suitable for indoor and outdoor use
Weight: 3.1kg.
Speed Control Range: 0-500Hz.
Dynamic Braking (DBr): Not Fitted.
Recommended Braking Resistance: N/A
Fixed Keypad with LED display
2 x Digital Inputs, 2 x Analogue/Digital Inputs, 1 x Analogue/Digital Output, 1 x Relay Contact set.
2 x RJ45 sockets for Modbus RTU or CANopen communications over RS485. (Parallel Ports).
Additional Options: Switched (SW): Fitted with Mains Isolator, Speed Potentiometer and Run Forward / Stop / Run Reverse selector switch
Input Current: 7.5A
Input protection required: 10A Fuse or MCB (Non-UL rating see Installation guide for full details)
Input Voltage: 200-240V Single Phase ±10% (max 240V) at 50-60Hz ±5%
EMC Compliance (Conducted Emissions): IEC EN61800-3:2004 Category C1 (Industrial and Domestic). Filter can be disconnected if required.
Wall mount.
Rated Ambient: 40°C; Operating Ambient: -20°C to 40°C. Must be frost and condensation free.
Ventilation space in front: [Not Specified]
Ventilation space above and below: 200mm
Ventilation space at sides: 10mm
Mounting via 4 x M4 bolts at rear on 148 x 189 mm centres.
Manufacturer part number is ODE-3-120043-1F1B; Suitable to replace ODE-3-120043-1F1Y
Made in the UK.
Download the Invertek Optidrive E3 Manual from the link below:-