TEC 180 Frame - 18.5kW 3ph 4 Pole AC Motor for 400V or 660V 3 phase supply in B35 Foot and Flange mounting form. Use with 400V Variable Frequency Drives or a fixed frequency mains supply at 50Hz.
Fitted with an incremental 2048ppr encoder and force vent cooling to privide full torque at zero speed and accurate speed control.
Fixed mains supply output is 18.5kW (25HP) x 1460RPM at 400V x 50Hz 3ph.
Full Load Current - 34.5A at 400V.
Overload - 150% x 60seconds.
Power Factor is 0.85 when mains connected at 50Hz.
Set terminal box links 'three a-breast' for 400V 'Delta' connection.
Set terminal box links ‘two at one side’ for 660V 'Star' connection.
350mm Wide x 730mm Long x 440mm high overall in its IP55 enclosure. Add 130mm to length for FVU
Foot mount on 15mm holes at 279mm wide x 241mm centres 121mm back from the shaft shoulder.
Flange mount on 19mm holes at 300mm PCD with 250mm diameter spigot in the 350mm diameter flange.
Shaft is 48mm dia x 110mm with 14mm wide key.
Weight is 119kg
Rated at 40C Ambient.
Ventilation space required at rear cooling air intake.
Full part number is - 18.543TECAB35-IE2/FVU/ENC2048
For Variable Speed use…
Part Time Output when Inverter powered is...
60Nm - 18.5kW (25HP) x 2900RPM at 100Hz
120Nm - 18.5kW (25HP) x 1465RPM at 50Hz
120Nm - 9.25kW (12.5HP) x 733RPM at 25Hz
120Nm - 1.85kW (2.5HP) x 145RPM at 5Hz
Continuous Output when Inverter powered is...
60Nm - 18.5kW (25HP) x 2900RPM at 100Hz
120Nm - 18.5kW (25HP) x 1465RPM at 50Hz
102Nm - 7.9kW (10.5HP) x 733RPM at 25Hz
60Nm - 0.9kW (1.25HP) x 145RPM at 5Hz
From Jan 1st 2017, three phase electric induction motors with a rated output of 0.75kW to 375kW and efficiency less than IE3 must be equipped with a variable speed drive (Inverter Drive). For exceptions, see EC Commission Regulation 640/2009.