WEG CFW500 Series AC Inverter for 0.37kW 400V three phase motor in V/F or Sensorless Vector Control to 1.6A. Converts fixed frequency three phase 400V input to variable frequency three phase 400V to control the speed of a standard AC induction motor.
Wall Mounted IP66 Power Module with Fixed keypad. (No I/O)
CFW500 IP66 Unit can be operated from the keypad without the need of a plug-in control module. If additional controls, external monitoring or Serial communication are required then an additional plug-in module is needed, see options below.
Output Current Rating: 1.6A (Continuous)
Overload: 150% for 60s or 200% for 3s
Frame Size A: 340mm (High) x 215mm (Wide) x 253mm (Deep).
Enclosure: IP66 (NEMA 4X); suitable for wall mounting.
Weight: 7kg.
Speed Control Range: 0-500Hz
Dynamic Braking (DBr): Fitted with Internal Brake Switch. Fit external brake resistor if Dynamic braking is required.
Braking Resistor: 127 Ohms; (Not supplied see option below)
Keypad Controls:
Start, Stop, Jog, Forward/Reverse, Raise Speed, Lower Speed. (Local/Remote key is also available but is only valid if fitted with an additional plug-in control board)
Input Current: 1.9A
Input Voltage: 380-480V Three Phase +10% -15% at 50-60Hz (48-62Hz)
EMC Compliance: Integrated filters to IEC EN61800-3 Category C3 (Industrial). Can be disabled if required using switch SW1. Input Ferrite Cores are also recommended, please see below.
Rated Ambient: 40°C
Ventilation space: 40mm Side, 50mm above; 60mm below, 50mm front.
Heat Loss at max output: 25W
Mounting: 4 x M5 Fixings at rear on 325mm x 200mm centres
Extended Warranty Available: When purchased with a WEG W22 Motor (see linked products below) the warranty for the motor and the AC Inverter can be extended to 3 years. Terms and Conditions apply, registration process is required.
Manufacturer part number is CFW500A01P6T4DB66C3H00 or 14992115