Invertek Optidrive E3 IP66 series AC Inverter for 0.75kW (1HP) 230V single phase motor in VxF control to 7A. Converts fixed frequency single phase 230V input to variable frequency 230V to control the speed of a Single Phase Cap Run (permanent-split capacitor) or shaded pole motor. Not suitable for use with high starting torque motors such as Cap Start (cap cap).
SW (Switched): includes integrated Potentiometer for speed control, Fwd/Stop/Rev and Enable switches.
Size 1: 161mm Wide x 162mm Deep x 232mm High. IP66 (Nema 4X) dust tight and resistant to water spray with UV protection. Suitable for indoor and outdoor use.
Weight: 2.3kg.
Overload: 150% x 60 seconds, 175% x 2.5 seconds
Speed Control Range: 0-120Hz.
Braking: No dynamic braking.
Integrated operator keypad with 6-digit LED display, 2 Analogue/Digital Inputs, 1 Digital Input, 1 Digital Input/Output, 1 Analogue/Digital Output, 1 Relay Contact set, RJ45 socket for Modbus RTU communications over RS485 or PC Connection to OptiTools Studio software
Additional Options: Switched (SW): Fitted with Mains Isolator, Speed Potentiometer and Run Forward / Stop / Run Reverse selector switch
Input Current: 9.3A
Input Voltage: 200-240V Single Phase ±10% (max 240V) at 50-60Hz ±5%
EMC Compliance: IEC EN61800-3:2004 Category C1 (Industrial and Domestic).
Wall mount.
Rated 40° Ambient.
Ventilation space in front: [Not Specified]
Ventilation space above and below: 200mm
Ventilation space at sides: 10mm
Mounting via 4 x holes for M4 bolts at rear on 148.5mm x 189mm centres.
Manufacturer part number is ODE-3-120070-1F1B-01 replaces ODE-3-120070-1F1Y-01
Made in the UK.
Download the Invertek Optidrive E3 Single Phase Output Manual from the link below:-