Siemens SINAMICS PM240 Power Module for 0.75kW (1HP) 400V Three Phase Motor to 2.2A at High Overload or 1.1kW (1.5HP) to 3.1A when Fan/Pump rated. Converts fixed frequency three phase 400V Input to variable frequency three phase 400V for speed and torque control of a standard AC Induction Motor when used with a compatible G120 Series Modular Control Unit.
POWER MODULE ONLY:- Add a compatible G120 Series Modular Control Unit and Operator Keypad to complete the G120 Inverter Drive.
Size A - 73mm Wide x 165mm Deep x 196mm High (excluding Control Unit). IP20
0.75kW, 2.2A: 150% overload for 57 seconds every 5 minutes. 200% for 3 seconds every 5 minutes. (High Overload / Constant Torque)
1.1kW, 3.1A 110% overload for 57 seconds every 5 minutes. 150% for 3 seconds every 5 minutes. (Fan/Pump Rated / Variable Torque)
Braking (DBr): 370 Ohm minimum external resistor (not supplied). Only fit resitor if Dynamic Braking is required. Use the 'Which Resistor' button on this page.
Input Voltage: Three Phase 380V-480V ± 10% at 50-60Hz ± 5%
Input Current: 3.3A at High Overload, 4.1A when Fan/Pump rated.
EMC Compliance: Integrated filters to IEC EN61800-3 Category C2 (Industrial and restricted domestic)
Rated 50°C ambient at High Overload, 40°C when Fan/Pump rated.
Ventilation space in front: 100mm
Ventilation space above: 80mm
Ventilation space below: 100mm
Heat Loss at max output: 40W
Mounting via 4 x M4 fixings at rear on 186mm x 62.3mm centres.
Manufacturer part number is 6SL3210-1PE13-2AL1.
Download the Siemens SINAMICS G120 Power Module PM240 Installation Manual from the link below:-