Invertek Optidrive E2 IP20 series AC Inverter for 1.1kW (1.5HP) 230V single phase motor in VxF control to 10.5A. Converts fixed frequency single phase 230V input to variable frequency 230V to control the speed of a Single Phase Cap Run (permanent-split capacitor) or shaded pole motor. Not suitable for use with high starting torque motors such as Cap Start (cap cap).
The Optidrive E2 has been superseded by the Optidrive E3.
The manufacturer recommends that customers migrate to the E3 as soon as possible as this is a direct replacement.
See linked product below for equivalent rating.
Size 2: 109mm Wide x 150mm Deep x 221mm High. IP20.
Overload: 150% x 60 seconds, 175% x 2.5 seconds
Speed Control Range: 0-120Hz.
Braking: To 47 Ohm minimum external resistor (not supplied) - See the Resistor options linked below or use the 'Brake Resistor Calculator' link at the bottom of this page.
Integrated operator keypad with 6-digit LED display, 2 Analogue/Digital Inputs, 1 Digital Input, 1 Digital Input/Output, 1 Analogue/Digital Output, 1 Relay Contact set, RJ45 socket for Modbus RTU communications over RS485 or PC Connection to OptiTools Studio software.
Input Current: 16.2A
Input Voltage: 200-240V Single Phase ±10% (max 240V) at 50-60Hz ±5%
EMC Compliance: IEC EN61800-3:2004 Category C1 (Industrial and Domestic). Can be disabled via screw if required.
Rated 50° Ambient.
Ventilation space in front: [Not Specified]
Ventilation space above and below: 75mm
Ventilation space at sides: 50mm
Mounting via 35mm DIN rail or 4 x holes for M4 bolts at rear on 63mm x 209mm centres.
Manufacturer part number is ODE-2-22110-1KB42-01. Equivalent to HP model number ODE-2-22015-1HB42-01.
Made in the UK.
Download the Invertek Optidrive E2 Single Phase Output Manual from the link below:-